Menu
Your Cart

Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops

Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
New Hot Out Of Stock
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
Royal Epoxy – TC110 (2 Kg) Epoxy Resin Engineered specifically for Bar Tops Tabletops Countertops
190.00AED
  • Stock: Out Of Stock

The most advanced crystal-clear epoxy coating on the market!

NO VOC, NO BPA, NO TOXIC

UV Resistant and Yellowing Resistant

High Gloss Like Mirror 

Self-Leveling

Automatic Antifoaming



  • Clear Crystal - Casting Epoxy Resin, highest quality resin components, eco-friendly and low odor, self-leveling and high gloss, anti-yellowing, cures 100% transparent and hard as a rock.
  • No Experience Needed - 1:1 by volume mix equal parts of resin and hardener. 45 minutes of working time until the resin starts to get sticky, long enough to be able to process most resin crafts with this high gloss epoxy resin kit. No bubbles if stirring the mixed resin evenly and slowly.
  • Coating on Surface – No Matter your surface it’s wood, plastic, steel etc. Just coating on dry and dust free surface will be enough. Normally Thickness for 1-2mm. Max 1-2cm.
  • Modified Epoxy Resin and Hardener from Raw Material, for Bar Tops Tabletops Countertops.
  • Working time 45-55 mins, cure time 5-7 hours. Hardness 80-85D.

 

DIRECTIONS FOR USE:

1. Measure ratio of 1:1 by volume (A resin and B Hardener), if by hand, mix slowly to avoid bubble, if   by sire machine, make speed as 300 rpm. All by one direction.

2. Surface must be dry and free of dust.

3. Wear protective gloves.

4. Use soap and water to clean your hand after use.

Write a review

Note: HTML is not translated!
Bad Good